Festo Type FRC-1/2-D-5M-MIDI-A Compressed Air Source Treatment Unit

Festo Type FRC-1/2-D-5M-MIDI-A Compressed Air Source Treatment Unit

Filters, regulators and lubricators can be purchased individually or as a combined filter-regulator (FR) or filter-regulator-lubricator (FRL) unit. It is recommended to install an FR unit if your equipment is self-lubricating and an FRL unit if your equipment requires lubrication. It is important to understand the air requirements of your system and components to know if and what components of an FRL unit are needed. The type of FRL components required is dependent on your system requirements, but it is recommended that every air system uses at least one filter and one pressure regulator. Most modern pneumatic tools use self-lubricating seals and as such, you often do not need to install a separate lubricator. If they aren’t self-lubricating, a lubricator should also be installed in the system. As a general rule, a pneumatic system’s order of installment is in this order: compressor, filter, regulator, and then a lubricator. Give careful consideration to the location of these devices because you may not need to treat your entire air system. To optimize the pneumatic system and reduce cost, only treat air where air needs to be treated.

Specification of FRC series Filter Regulator Lubricator:

Main Parts Material of FRC series Filter Regulator Lubricator:

Dimension of FRC series Filter Regulator Lubricator:

Other Pneumatic Products BRANDO supply:

2/2 Way Pneumatic Valves	3/2 Way Pneumatic Valves	5/2 Way Pneumatic Valves	5/3 Way Pneumatic Valves
Namur Solenoid Valves	Air Pilot Valves	Pneumatic Cylinders	Silencers and Fittings

Focus on your demands, Offer you best solution:

√ Contact us if some points you have doubt

√ Contact us if somewhere need to change
√ Contact us if not the one you are looking for

√ Contact us if you are doing designing

Welcome to your any question and inquiry!